Home
EN
Location
Documentation Home
Palo Alto Networks
Support
Live Community
Knowledge Base
>
Clear
Determine Your Active/Active Use Case
Updated on
Thu Sep 19 19:59:31 UTC 2024
Focus
Download PDF
Updated on
Thu Sep 19 19:59:31 UTC 2024
Focus
Home
PAN-OS
High Availability
Set Up Active/Active HA
Determine Your Active/Active Use Case
Download PDF
Determine Your Active/Active Use Case
Table of Contents
Filter
Expand All
|
Collapse All
Next-Generation Firewall Docs
Getting Started
Administration
Version
Cloud Management of NGFWs
PAN-OS 10.0 (EoL)
PAN-OS 10.1
PAN-OS 10.2
PAN-OS 11.0
PAN-OS 11.1 & Later
PAN-OS 9.1 (EoL)
Networking
Version
PAN-OS 10.1
PAN-OS 10.2
PAN-OS 11.0
PAN-OS 11.1 & Later
AIOps
Incidents & Alerts
Release Notes
Version
Cloud Management and AIOps for NGFW
PAN-OS 10.0 (EoL)
PAN-OS 10.1
PAN-OS 10.2
PAN-OS 11.0
PAN-OS 11.1
PAN-OS 11.2
PAN-OS 8.1 (EoL)
PAN-OS 9.0 (EoL)
PAN-OS 9.1 (EoL)
Previous
Configure Active/Active HA
Next
Use Case: Configure Active/Active HA with Route-Based Redundancy
Determine Your Active/Active Use Case
Determine which type of use case you have and then select the corresponding procedure to configure active/active HA.
If you are using
Route-Based Redundancy
,
Floating IP Address and Virtual MAC Address
, or
ARP Load-Sharing
, select the corresponding procedure:
Use Case: Configure Active/Active HA with Route-Based Redundancy
Use Case: Configure Active/Active HA with Floating IP Addresses
Use Case: Configure Active/Active HA with ARP Load-Sharing
If you want a Layer 3 active/active HA deployment that behaves like an active/passive deployment, select the following procedure:
Use Case: Configure Active/Active HA with Floating IP Address Bound to Active-Primary Firewall
If you are configuring
NAT in Active/Active HA Mode
, see the following procedures:
Use Case: Configure Active/Active HA with Source DIPP NAT Using Floating IP Addresses
Use Case: Configure Separate Source NAT IP Address Pools for Active/Active HA Firewalls
Use Case: Configure Active/Active HA for ARP Load-Sharing with Destination NAT
Use Case: Configure Active/Active HA for ARP Load-Sharing with Destination NAT in Layer 3
Previous
Configure Active/Active HA
Next
Use Case: Configure Active/Active HA with Route-Based Redundancy
