QoS CIR Support For Aggregate Bandwidth
Table of Contents
3.1.6 Cloud Managed
Expand all | Collapse all
-
- Onboard a Non-ECMP Site
- Set Additional Information Tag
- Configure BGP
- Customize Prisma Access Objects Names using CloudBlade Tag
- Edit Application Policy Network Rules
- Understand Service and Data Center Groups
- Verify Standard VPN Endpoints
- Configure Standard Groups
- Assign Domains to Sites
- Use Groups in Network Policy Rules
- Enable, Pause, Disable, and Uninstall the Integration
QoS CIR Support For Aggregate Bandwidth
In Aggregate Bandwidth licensing mode, the
bandwidth allocation is done for a compute location on Prisma Access.
The number of tunnels terminating within a compute location and
SPN share the aggregate bandwidth allocated. You must configure
the CIR for specific tunnels terminating on an SPN within a compute
location to guarantee the Quality of Service (QoS).
Follow
these steps to configure Quality of Service (QoS) in Prisma Access
Cloud Management interface for aggregate bandwidth, including adding
a QoS profile, enabling QoS, and tagging the QoS profile on the
Prisma SD-WAN web interface.
- Enable QoS for your remote network locations.
- Select Manage ServiceSetup RemoteNetworks Bandwidth Management.
- Determine the Prisma Access locations where you want
to deploy QoS; then find the compute location that corresponds to
each Prisma Access location.Each Prisma Access location is allocated bandwidth from its compute location, and you must know the name of the compute location for the locations where you want to allocate QoS.
- Enable QoS at a compute location level in the QoS column.Any change in settings apply to all locations corresponding to this compute location.
- Edit the QoS settings for the compute location.
- Select the guaranteed bandwidth ratio, which
is a ratio based on the entire allocated bandwidth for the compute
location.For example, if you have allocated bandwidth of 1001 Mbps for the US Southwest compute location, and you enter a Guaranteed Bandwidth Ratio of 82%, the guaranteed bandwidth for that compute location is 820.82 Mbps.By default, each remote network is given a percentage equal to the number of connections. For example, given four connections in a compute location and a total guaranteed bandwidth of 820.82 Mbps, each location receives 25% of that bandwidth, which is 205.2 Mbps.
- Create New QoS profile or Manage to edit an existing QoS profile.
- Customize QoS settings for remote network sites in a compute location. If you have multiple remote networks per compute location and want to change either the bandwidth ratio or QoS profile for each remote network, select Customize and change the bandwidth allocation ratio, QoS profile, or both.
- Select Commit and Push to save the changes.
- Select the guaranteed bandwidth ratio, which
is a ratio based on the entire allocated bandwidth for the compute
location.
- In Prisma SD-WAN, navigate to the SiteInterfaces/Circuits and assign
interface/circuit level tags in the following format. Format:<profile_name>:<qos_bandwidth>Example:prisma_qos:qos_test:20The tags can be both ECMP and Non-ECMP. For Non-ECMP, go to the site on Prisma SD-WAN, where you wish to customize QoS and tag the interface or circuit. In the example shown below, the allocated bandwidth is 40%.In ECMP, enabled sites allow customizations per ECMP link. You must tag the ECMP links where you want to apply the QoS customization.After the tags are applied, the CloudBlade integration applies these changes on the Prisma Access Cloud Management interface.