Autonomous DEM
Time Range Filter
Table of Contents
Time Range Filter
Use the Time Range selection filter to view metrics for a specific
time range.
| Where Can I Use This? | What Do I Need? |
|---|---|
|
|
The Time Range selection filter appears at the top of all the
ADEM dashboards except the Settings
dashboard. You can filter data to display in the dashboard based on the Time
Range you select.
The time is localized, so you can filter based
on the local time for your region. Data is fetched every minute,
but the number of datapoints shown in most histograms vary according
to the Time Range selected.
For your convenience, ADEM lets you pick the Time Range
from a few predefined ranges or configure your own date and time range. Datapoints shown
in most histograms vary according to the Time Range selected:
| If the Time Range selected is... | Data point interval in histograms is shown for every... |
|---|---|
| <48 hours | 5 minutes |
| 48 hours - <7 days | 15 minutes |
| 7 days - <10 days | 30 minutes |
| 10 days - <30 days | 1 hour |
| >30 days | 3 hours |
| Custom | You can set a custom time interval (for example,
start at 5:00 pm on June 1 and end at 4:00 pm on June 2) in addition
to the pre-populated Time Range selections
available in the filter. To create a custom time range:
|