set deviceconfig system eth2

Table of Contents

set deviceconfig setting wildfire

set deviceconfig system eth3

set deviceconfig system eth2

Description

Configure the eth2 interface.

Hierarchy Location

set deviceconfig system

Syntax

eth2 { 
default-gateway <ip-address>;  
ip-address <ip-address>; 
mtu <value>; 
netmask <ip-netmask>; 
speed-duplex {100Mbps-full-duplex | 100Mbps-half-duplex | 10Mbps-full-duplex | 10Mbps-half-duplex | 1Gbps-full-duplex | 1Gbps-half-duplex | auto-negotiate}; 
permitted-ip <ip-address/netmask>; 
service disable-icmp {no | yes}; 
}

Options

+ default-gateway — IP address of the default gateway for the eth2 interface.

+ ip-address — IP address for the eth2 interface.

+ mtu — Maximum Transmission Unit (MTU) for the eth2 interface.

+ netmask — Netmask for the eth2 interface.

+ speed-duplex — Interface speed (10Mbps, 100Mbps, 1Gbps, or autonegotiate) and duplex mode (full or half) for the eth2 interface.

> permitted-ip — IP addresses allowed to access the eth2 interface. If you specify a netmask with the IP address, the netmask must be in slash notation. For example, to specify a Class C address, enter: 10.10.10.100/24 (not 10.10.10.100 255.255.255.0).

> service-disable — Disable ICMP for the eth2 interface.

Sample Output

admin@wf-500(active-controller)# show deviceconfig system eth2 
eth2 { 
    ip-address 10.10.10.120; 
    netmask 255.255.255.0; 
    service { 
      disable-icmp no; 
    } 
    speed-duplex auto-negotiate; 
    mtu 1500; 
  }

Required Privilege Level

superuser, deviceadmin

set deviceconfig setting wildfire

set deviceconfig system eth3