Focus

PAN-OS Web Interface Help

Policies > NAT

Table of Contents

Policies > NAT

If you define Layer 3 interfaces on the firewall, you can configure a Network Address Translation (NAT) policy

to specify whether source or destination IP addresses and ports are converted between public and private addresses and ports. For example, private source addresses can be translated to public addresses on traffic sent from an internal (trusted) zone to a public (untrusted) zone. NAT is also supported on virtual wire interfaces.

NAT rules are based on source and destination zones, source and destination addresses, and application service (such as HTTP). Like security policies, NAT policy rules are compared against incoming traffic in sequence, and the first rule that matches the traffic is applied.

As needed, add static routes to the local router so that traffic to all public addresses is routed to the firewall. You may also need to add static routes to the receiving interface on the firewall to route traffic back to the private address.

The following tables describe the NAT and NPTv6 (IPv6-to-IPv6 Network Prefix Translation) settings:

Looking for more?

See NAT

Security Policy Optimizer

NAT Policies General Tab