Focus

PAN-OS Web Interface Reference

Network > Interfaces > Tunnel

Table of Contents

Network > Interfaces > Tunnel

Use the following fields to configure a tunnel interface:

Tunnel Interface Settings	Configure In	Description
Interface Name	Tunnel Interface	The read-only Interface Name is set to tunnel. In the adjacent field, enter a numeric suffix (1-9,999) to identify the interface.
Comment		Enter an optional description for the interface.
Netflow Profile		If you want to export unidirectional IP traffic that traverses an ingress interface to a NetFlow server, select the server profile or click Netflow Profile to define a new profile (see Device > Server Profiles > NetFlow). Select None to remove the current NetFlow server assignment from the interface.
Virtual Router	Tunnel InterfaceConfig	Assign a virtual router to the interface, or click Virtual Router to define a new one (see Network > Virtual Routers). Select None to remove the current virtual router assignment from the interface.
Virtual System		If the firewall supports multiple virtual systems and that capability is enabled, select a virtual system (vsys) for the interface or click Virtual System to define a new vsys.
Security Zone		Select a security zone for the interface, or click Zone to define a new zone. Select None to remove the current zone assignment from the interface.
Management Profile	Tunnel InterfaceAdvancedOther Info	Management Profile—Select a profile that defines the protocols (for example, SSH, Telnet, and HTTP) you can use to manage the firewall over this interface. Select None to remove the current profile assignment from the interface.
MTU	Tunnel InterfaceAdvancedOther Info	Enter the maximum transmission unit (MTU) in bytes for packets sent on this interface (576-9,192; default is 1,500). If machines on either side of the firewall perform Path MTU Discovery (PMTUD) and the interface receives a packet exceeding the MTU, the firewall returns an ICMP fragmentation needed message to the source indicating the packet is too large.
For an IPv4 address
IP	Tunnel InterfaceIPv4	Click Add, then perform one of the following steps to specify a static IP address and network mask for the interface. Type the entry in Classless Inter-Domain Routing (CIDR) notation: ip_address/mask (for example, 192.168.2.0/24). Select an existing address object of type IP netmask. Click Address to create an address object of type IP netmask. You can enter multiple IP addresses for the interface. The forwarding information base (FIB) your system uses determines the maximum number of IP addresses. To delete an IP address, select the address and click Delete.
For an IPv6 address
Enable IPv6 on the interface	Tunnel InterfaceIPv6	Select to enable IPv6 addressing on this interface.
Interface ID	Tunnel InterfaceIPv6	Enter the 64-bit extended unique identifier (EUI-64) in hexadecimal format (for example, 00:26:08:FF:FE:DE:4E:29). If you leave this field blank, the firewall uses the EUI-64 generated from the MAC address of the physical interface. If you enable the Use interface ID as host portion option when adding an address, the firewall uses the interface ID as the host portion of that address.
Address	Tunnel InterfaceIPv6	Click Add and configure the following parameters for each IPv6 address: Address—Enter an IPv6 address and prefix length (e.g. 2001:400:f00::1/64). You can also select an existing IPv6 address object or click Address to create an address object. Enable address on interface—Select to enable the IPv6 address on the interface. Use interface ID as host portion—Select to use the Interface ID as the host portion of the IPv6 address. Anycast—Select to include routing through the nearest node.

Network > Interfaces > Loopback

Network > Interfaces > SD-WAN