Addressed Issues in Panorama Plugin for VMware NSX 2.0.2
Table of Contents
Expand all | Collapse all
-
-
-
-
- Features Introduced in Zero Touch Provisioning 2.0
- Known Issues in the Zero Touch Provisioning 2.0.4 Release
- Known Issues in the Zero Touch Provisioning 2.0.3 Release
- Known Issues in the Zero Touch Provisioning 2.0.2 Release
- Known Issues in the Zero Touch Provisioning 2.0.1 Release
- Known Issues in the Zero Touch Provisioning 2.0.0 Release
- Limitations
-
-
Addressed Issues in Panorama Plugin for VMware NSX 2.0.2
The following list describes issues addressed
in the Panorama Plugin for VMware NSX 2.0.2.
PLUG-421
Fixed an issue where the service manager
status continuously switched from registered to out of sync.
PLUG-385
Fixed an issue that did not delete service
manager configuration from the NSX Manager when the service manager
was successfully deleted from Panorama.
PLUG-378
Fixed an issue where the service manager
status goes Out of Sync upon upgrading Panorama to 8.1.0.
PLUG-377
Fixed an issue where IP addresses for
security groups in NSX Manager fell out of sync with those in Panorama.
PLUG-357
Fixed an issue that prevented the NSX
plugin from correctly handling non-ASCII characters in updates received
from NSX Manager. This caused the deletion of dynamic address group
objects containing non-ASCII characters after performing a manual
config sync.
PLUG-334
Fixed an issue where, after disabling
the connection between the Secondary HA Panorama and the NSX Manager,
the Primary HA Panorama disables the connection with NSX Manager
as well.
PLUG-252
Panorama now uses TLSv1.2 when communicating
with NSX Manager.