Addressed Issues in Panorama Plugin for VMware NSX 3.2.3
Table of Contents
Expand all | Collapse all
-
-
-
-
- Features Introduced in Zero Touch Provisioning 2.0
- Known Issues in the Zero Touch Provisioning 2.0.4 Release
- Known Issues in the Zero Touch Provisioning 2.0.3 Release
- Known Issues in the Zero Touch Provisioning 2.0.2 Release
- Known Issues in the Zero Touch Provisioning 2.0.1 Release
- Known Issues in the Zero Touch Provisioning 2.0.0 Release
- Limitations
-
-
Addressed Issues in Panorama Plugin for VMware NSX 3.2.3
The following issues are addressed in
the Panorama plugin for VMware NSX 3.2.3.
PLUG-8404
Upgrading from NSX Plugin 2.0.6 to 3.2.2
resulted in panorama losing the NSX Plugin configuration.
This issue is fixed in Panorama Plugin for NSX, version 3.2.3.
PLUG-8395
An active Panorama should always be in
sync with the NSX-T Manager. However after recovering from a split
brain (a state where the connectivity between the two Panaromas
is down due to which both of them behave as active), it is observed
that the active Panorama goes out of sync with the NSX-T Manager.
This issue is addressed in Panorama Plugin for NSX, version
3.2.3 by fixing the timing of the revision number update between
the config sync flag and the database.
PLUG-5982
Fixed an issue that caused a commit failure
on a FIPS-enabled Panorama with the Panorama Plugin for VMware NSX
installed.
PLUG-5425
NSX-T Service Manager displayed the Last
Dynamic Update only for the first Service Manager and not the second
Service Manager.
This issue is fixed in Panorama Plugin for NSX, version 3.2.3.
With this fix, the GUI now displays the Last Dynamic Update for
all Service Managers.
PLUG-8219
When the Panorama plugin for VMware NSX checks for connectivity
before comparing the configuration between Panorama and the NSX-T
Manager, the plugin creates a log entry for the connectivity check.
The log can be viewed in plugin_vmware_nsx_nsxt-mon.log.
PLUG-8218
Fixed an issue that caused full-sync
API calls, from Panorama to NSX-T Manager, to fail for a given security
group due to a connectivity issue between Panorama and NSX-T Manager.
PLUG-8217
You can now use the Panorama CLI to disable the automatic
full sync that occurs when the connection status changes (Invalid
Credentials to Registered and No Connection to Registered) between
Panorama and all NSX-T managers in your deployment.
request plugins vmware_nsx nsx_t trigger-full-sync enable No Do not trigger full sync Yes Trigger full sync