Install the M-600 Appliance in a 19” Equipment Rack
Expand all | Collapse all
Install the M-600 Appliance in a 19” Equipment Rack
Learn how to install an M-600 appliance in an equipment
rack using the provided four-post rack kit.
The following procedure describes how to install
the M-600 appliance in a four-post equipment rack. The rack kit
includes the hardware required to install the appliance in most
equipment racks. Extra screws and washers are included.
Attach the inner-rails to each side of the appliance
by aligning the square holes on each rail with the rail hooks on
the appliance and then sliding the rails toward the front of the
appliance to engage the hooks. Secure the back part of each rail
to the appliance using one M4 screw for each rail.
The inner-rails also use a pressure-lock clip (one
on each rail) that locks the rails to the appliance. Remove the
M4 screw and pull the metal tab on the clip to remove the rail from
the appliance.
Install one outer rack-mount rail to each side of the equipment
rack. Push the two rail hooks (on the front and back of each rail)
in to the square rack holes and push down to engage the hooks. The
release buttons located above each rail hook will depress as you push
the rail hooks in to the square holes. Secure the back of each rail to
the rack using two M5 screws (with washers) for each rail. The following
image shows the right side of the rack if you are facing the front
of the rack.
Install the appliance in to the equipment rack by sliding
the inner-rails in to the outer rack-mount rails until the appliance
stops (about halfway in to the rack). Push the inner-rail release clips
on each side of the two rails to release the appliance and then continue
to slide the appliance in to the rack until the front of the appliance
is flush with the front of the rack. The inner-rail release clips
are shown in step 1.
Secure the front of the appliance to the rack by turning
the front thumb screws on each rail clockwise until tight.