M-600 Appliance Front Panel
Table of Contents
M-600 Appliance Front Panel
Learn about the M-600 appliance front-panel components.
The following image shows the front panel of the M-600
appliance and the table describes each front-panel component.
Item | Component | Description |
|---|---|---|
1 | Power button | Press this button to power on or power off
the appliance. Powering off the appliance with this button puts
the appliance in standby power mode. To completely power off the
appliance, you must disconnect the AC power cords from both power supplies. |
2 | Reset button | Press this button to reboot the appliance. |
3 | Power LED | Solid green indicates that the appliance
is powered on. |
4 | Power failure LED | Solid red indicates that either a power
supply failed or that there is no power source connected to a power
supply. |
5 | Hard-disk drive (HDD) LED | Blinking yellow indicates IDE channel activity (SAS/SATA
drive) on the front log drives. |
6 | System information (overheat and UID) LED |
|
7 | Hard-disk drives (HDDs) | Disk drive bays and HDDs used for log storage. From left to right (starting at the top-left), the
drive bays are labeled A1, A2, B1, B2, C1, C2, D1, D2, E1, E2, F1,
and F2. By default, the M-600 ships with four HDDs installed in A1,
A2, B1, and B2. You can install up to eight additional drives (four
additional RAID 1 pairs) in the remaining drive bays to increase log
storage capacity. Each pair of drives is in a RAID 1 configuration. For example, A1/A2 is a RAID 1 pair and B1/B2
is a RAID 1 pair. For details on
storage capacity, refer to the Panorama Datasheet. For details on adding additional
storage to the appliance, refer the Panorama Administrator’s Guide
on the Technical Documentation Portal for the
release version running on your appliance. |
8 | Hard-disk drive (HDD) LEDs | Status LEDs—two for each log drive:
|