M-300 Appliance Back Panel
Table of Contents
M-300 Appliance Back Panel
Learn about the M-300 appliance back-panel components.
The following image shows the back panel of the M-300
appliance and the table describes each back-panel component.
Item | Component | Description |
|---|---|---|
1 | Power supplies | Use the AC power supply inputs to connect power
to the appliance. The second power supply is for redundancy. |
2 | Ethernet ports | Two RJ-45 100Mbps/1Gbps/10Gbps Ethernet ports.
While facing the back of the appliance, the ports are labeled as
follows: The port labels are located on top of the appliance.
For information on configuring
these ports, refer to the Panorama™ Administrator’s Guide on the Technical
Documentation Portal for the release version running on your
appliance. |
3 | USB ports | Not used. |
4 | IPMI port | Not used. |
5 | Console port | Use this port to connect a
management computer to the appliance using a 9-pin serial cable and
terminal emulation software. The console connection provides
access to appliance boot messages, the Maintenance Recovery Tool
(MRT), and the command line interface (CLI). If your
management computer does not have a serial port, use a USB-to-serial converter. Use
the following settings to configure your terminal emulation software
to connect to the console port:
|
6 | Unique Identification (UID) LED | UID LED that illuminates bright blue when
you push the UID button on the front of the appliance. For
information on using the UID feature, see the UID button description
for the M-300 Appliance Front Panel. |