set deviceconfig system eth3

Table of Contents

set deviceconfig system eth2

set deviceconfig system panorama local-panorama panorama-server

set deviceconfig system eth3

Description

Configure the eth3 interface.

Hierarchy Location

set deviceconfig system

Syntax

eth3 { 
default-gateway <ip-address>;  
ip-address <ip-address>; 
mtu <value>; 
netmask <ip-netmask>; 
speed-duplex {100Mbps-full-duplex | 100Mbps-half-duplex | 10Mbps-full-duplex | 10Mbps-half-duplex | 1Gbps-full-duplex | 1Gbps-half-duplex | auto-negotiate}; 
permitted-ip <ip-address/netmask>; 
service disable-icmp {no | yes}; 
}

Options

+ default-gateway — IP address of the default gateway for the eth3 interface.

+ ip-address — IP address for the eth3 interface.

+ mtu — Maximum Transmission Unit (MTU) for the eth3 interface.

+ netmask — Netmask for the eth3 interface.

+ speed-duplex — Interface speed (10Mbps, 100Mbps, 1Gbps, or autonegotiate) and duplex mode (full or half) for the eth3 interface.

> permitted-ip — IP addresses allowed to access the eth3 interface. If you specify a netmask with the IP address, the netmask must be in slash notation. For example, to specify a Class C address, enter: 10.10.10.100/24 (not 10.10.10.100 255.255.255.0).

> service-disable — Disable ICMP for the eth3 interface.

Sample Output

admin@wf-500(active-controller)# show deviceconfig system eth3 
eth3 { 
    ip-address 10.10.20.120; 
    netmask 255.255.255.0; 
    service { 
      disable-icmp no; 
    } 
    speed-duplex auto-negotiate; 
    mtu 1500; 
  }

Required Privilege Level

superuser, deviceadmin

set deviceconfig system eth2

set deviceconfig system panorama local-panorama panorama-server