: Install the ION 1000 by Replacing an Existing Router
Focus
Focus

Install the ION 1000 by Replacing an Existing Router

Table of Contents

Install the ION 1000 by Replacing an Existing Router

Install the Prisma SD-WAN ION 1000 by replacing an existing router to directly terminating the MPLS.
Install the ION 1000 to replace an existing router, directly terminating the MPLS, especially in environments where routers are not already present or required.
Configure the ION 1000 as a drop-in replacement for the WAN Router. This mode is most useful for saving cost at new sites that are designed without a traditional router in mind.
While this mode is used to remove an existing router at a site, it is sometimes preferred to deploy with an existing router. In such a scenario, the existing router is unplugged or disabled after all functions are verified.