Wall Mount the ION 1000

1. Gather the wall mounting brackets, also referred to as the ear brackets.
   These brackets enable you to anchor the ION 1000 to the wall.

2. Place the ION 1000 upside down and locate the four (4) screw holes on each corner of the device.

3. Place the ear brackets on each side of the device and align the screw holes on the bracket and the device.
4. Fasten the ear brackets with the screws to secure the brackets.

5. Place the device on the wall where you plan to mount it and mark the wall to insert the wall anchors for each screw hole.
6. Use a power drill to apply the four (4) white wall anchors into the screw holes.
7. Insert the screws partially into the anchors, leaving a tiny gap to hang the ear bracket.

8. Hang the device onto the wall, making sure to match the four (4) screw holes on the ear bracket with the four (4) screws on the wall.
9. Fasten the screws securely to mount the device on the wall.
10. Verify that the ION 1000 is securely mounted on the wall.
    Do not remove the rubber pads from the Prisma SD-WAN ION 1000 to prevent overheating and damage.