PA-7500 Series Back Panel
Table of Contents
Expand all | Collapse all
PA-7500 Series Back Panel
Learn about the back panel components of the PA-7500 Series Firewall.
The following image shows the back panel of the PA-7500 Series firewall and the table
describes each back panel component.
Item
|
Component
|
Description
|
---|---|---|
1
|
Back slot cards
|
Two slots that house Switch Fabric Cards (SFCs). One SFC must be
installed while a second SFC can be installed for redundancy.
View the PA-7500 Series Module and Interface Card Descriptions for more
information on the slot cards and their components.
|
2
|
Fan assemblies
|
Up to fifteen fan assemblies that provide the appliance with cooling
and ventilation. The dual-rotor fan assemblies can be individually
replaced.
|
3
|
Ground stud
|
Two-post stud used to ground the appliance to earth ground. Use the
provided ground lug to connect a grounded cable to the two-post
stud.
|
4
|
Power supplies
|
Ten power supply slots that provide AC or DC power to the chassis. A
chassis with low line input voltage (90V, 110/120V, 132V) requires a
minimum of eight power supplies while a chassis with high line input
voltage (180V, 200/240V, 305V) requires a minimum of four power
supplies.
The minimum number of power supplies (four for high line and
eight for low line) are not enough to establish full power
redundancy in a fully loaded chassis.
To provide full redundancy using high line power supplies, you
must install eight power supplies. A fully redundant power
configuration means that half of the installed power supplies
can fail and the appliance and all installed line cards still
function.
On the back panel of the chassis, the power supplies are numbered as
follows:
For more information on connecting power to the firewall, see Connect Power to the PA-7500 Series Firewall.
|