Focus

Prisma SD-WAN ION CLI Reference

debug flow

Table of Contents

debug flow

Use the debug flow command to create, display, or delete a filter when enabling data plane debugging to reduce the ION device load. The match criteria for the filter must be one or two host IP addresses, one or two port numbers, a specific protocol type, or a particular ether-type. The filter ID is mandatory for creating and delete options (values between 1 and 8). All are used with the view option to display all filters on the device.

Command

debug flow (create | view | delete) id= [ host1= | host2= | port1= | port2= | protocol= | ether-type= ]

Options

id	Enter the filter ID.
host1	Enter the source IP address.
host2	Enter the destination IP address.
port1	Enter the source port address.
port2	Enter the destination port address.
protocol	Enter the protocol for creating a filter. For example TCP, UDP, ICMP, etc.
ether-type	Enter the Ether Type value for the protocol used. For example, 0x0800 for Internet Protocol version 4 (IPv4).

Command Notes

Role	Super
Related Commands	—
Introduced in	Release 4.6.1

Example

debug flow create id=1 host1=10.10.101.11 host2=192.168.22.33
				       
				       debug flow view id=8
				       ID     Host1          Host2        Port1 Port2 EtherType Protocol
				       8      192.168.23.2   172.168.23.2   23    17      6          9
				
				       debug flow delete id=8
				       Deleted:8
				    
				       debug flow view all
				       ID     Host1           Host2           Port1 Port2 EtherType Protocol
				       2      172.20.73.191   172.20.73.183    23    80     234      17
				       6      172.20.73.121   172.20.73.170    23    80     289       1

 debug flow view all
ID	Host1			Host2	Port1	Port2	EtherType	Protocol
2	10.2.15.103			0	0
1	2001:10:2:15::103		0	0

debug controller reachability

debug ipfix