Configuring a virtual wire includes configuring two Ethernet
ports that use the same link speed as virtual wire interfaces, enabling
link state pass through, and adding each interface to a security
zone. You can optionally create a security policy rule to allow
Layer 3 traffic, and enable multicast firewalling, IPv6 firewalling,
LLDP, and non-IP protocol protection (for PAN-OS 8.0 and later releases).
The following task shows how to configure
two
Virtual Wire Interfaces (Ethernet
1/3 and Ethernet 1/4 in this example) to create a virtual wire.
The two interfaces must have the same
Link Speed and
transmission mode (
Link Duplex). For example,
a full-duplex 1000Mbps copper port matches a full-duplex 1Gbps fiber
optic port.